All air conditioners produce condensate as a part of the cooling process. Usually, it collects in the AC drip pan from where it drains out via a drainpipe. Nevertheless, sometimes the condensate is unable to drain, resulting in stale and stagnant standing water. If the amount of collected condensate in the drip pan or drip tray continues to increase, it starts to spill. This spillage results in puddles of water indoors and wets the walls.
Problem With Dripping Water
Dripping water from the AC is a nuisance and a menace best avoided in any indoor space.
1. Water puddles on the floor can cause accidents like slipping and falling.
2. In case you have wooden floorboards, it can cause rotting.
3. Wet walls will spoil the paint job and also lead to mold.
4. If water enters any electrical point, it may result in a short circuit or a spoiled appliance.
As is quite clear, an overflowing AC drip pan is a cause for concern and requires quick and precise action.
Cause Of AC Drip Pan Being Full
Several conditions result in a full drip pan. Some of them are:
1. Blockage In Drain Pipe – The most common source of the problem is a blockage in the drain pipe. Typically, duct, dirt, corroded pieces of the drip tray accumulate inside the drain line instead of flushing outside. This debris attracts more debris, and over time the accumulation grows so big that it does not allow the water collected in the drip tray to drain outside. Consequently, the drip pan becomes full. If you are on top of your annual preventive maintenance schedule, such a thing should not happen. Sadly, most of us feel maintenance is a wasteful activity and overlook it entirely.
Unclogging the drain pipe is not very difficult if you have a wet and dry vacuum cleaner. Using it, you can suck out the clogging. This will allow the water to flow out without any trouble once more.
2. Frozen Coils – It has been seen that frozen coils can also lead to the drip pan being full. If the rate at which the ice over the coil melts is faster than the flushing capacity of the drainpipe, there will be water in the drip tray. Coils may ice over or freeze for various reasons like low refrigerant level, dirty air filter restricting airflow, etc. Again, the thing of importance here is to realize that timely maintenance of the AC will address these reasons much before they can lead to a problem.
When you encounter the problem of frozen coils, it would be best to check the condition of the air filter. If it is dirty or clogged, swap it out with a new one. In case the problem is still nowhere near satisfactorily addressed, call your HVAC technician.
3. Incorrect Installation – It is our natural tendency to try and cut costs where possible. When we come across a person who claims to install the AC much cheaper than what others are quoting, we naturally get attracted to the enticing offer. Alas, we don’t consider the fact that the person is untrained and, hence, charging below the industry standard. Mostly they do a hash job and muck up installation. One of its consequences is that the drip pan is unable to flush the condensate through the drainpipe. Instead, it keeps collecting water until such time that it overflows, leaving a mess for you to clean.
Whenever your AC or furnace or both need a hands-on job, it is in your best interest to only hire such contractors or technicians who are trained, experienced, and NATE certified. All these achievements come at a price, but you can rest assured it is no more than what the industry has determined.
What To Do When The AC Drip Pan Is Full?
When you notice water puddles on the floor near the indoor unit or dampness on the walls, it is a sure sign of an overflowing drip pan. So here’s how you need to proceed:
1. Cut the power supply to the HVAC system. Water and electricity are not a good mix. Therefore, it is safer to unplug the AC before doing anything else.
2. Now check the drain pipe. If it is not fitted correctly, tighten it. In case it has holes or cracks, you will have to replace it. However, if there is a blockage, you can remove it with your vacuum cleaner. Ideally, the water collected in the drip tray will drain without any problem.
3. Next, check the condition of the air filter. If it is dirty, immediately replace it with a clean one.
4. Now plug back the system to the power source and let it run for some time. If there is no more standing water in the drain pan, you are all set. Nevertheless, if the problem reoccurs, best call your HVAC technician for the heart of the issue might be elsewhere dealing with, which calls for expertise.
Prevention Is Better Than Cure
The most effective way to prevent your AC drip pan from becoming full of water is by scheduling its annual maintenance on time and seeing it through each year. Any delay means more chances of problems becoming serious issues. If you wish to avoid any similar situations from cropping, take care of your heating and cooling system and ensure that it is well looked after.
If you reside in West Palm Beach, Florida, and have missed the routine maintenance of your HVAC system, schedule one now. The expert team of technicians at Aztil Air Conditioning is continuously gunning to ensure that your HVAC systems are well maintained and repaired quickly and efficiently. We are a family-owned business that promises its clients world-class HVAC services at an affordable cost. We also provide emergency services, so you don’t have to remain in discomfort for long. You can reach out to us at any time as we are always open. To book an appointment, call us at +1-888-729-8452.